Logo Jst No Paddings MiniLogo Jst No Paddings MiniLogo Jst No Paddings MiniLogo Jst No Paddings Mini
  • HOME
  • Services
  • E-learning
  • Blog
  • About me
  • Contact
✕
English
  • Czech

Nadca 207 – Preparation for heat treatment

Categories
  • Nadca 207
Tags

I have already described the Nadca 207-2022 recommendation regarding radii on my blog

herehttps://www.jstconsultancy.cz/nadca-207-2022-and-preparation-of-dies-for-heat-treatment/?lang=en,

and regarding the placement of the thermocouples here

https://www.jstconsultancy.cz/nadca-207-2022-thermocouples-placement/?lang=en

However, there are also other rules that I will mention later. I would like to thank Kind&Co, the supplier of steel for die casting dies within Nadca 207 – 2022, for the illustrative images.

Inside radii smaller than 0.250” (5.0 mm) should be avoided in large tooling to reduce the risk of quench cracking.

There is still a risk of cracking when the geometry of the tool is complex. Larger steps and complex geometry will require larger radii, typically ranging in size from 0.250” (5.0 mm) to 0.400” (10 mm). Steps larger than 5.9” (150 mm) may require a more generous radius, an example is a radius of 0.500” (13 mm) or greater.

Also, all holes should have a minimum 0.120” (3 mm) chamfer at the surface.

Holes drilled prior to heat treat should have at least 0.240” (6 mm) wall thickness between them. 0.400” (10 mm) minimal wall thickness is optimal.

All burrs should be completely removed after machining.

Any regions where one machining detail does not break through to another detail that results in a thin covering over an open area must be avoided.

Webs in between details on any die should not come to sharp knife edges. Preferably, these webs should be either eliminated, or significantly increased in thickness to reduce the risk of cracking

 

February  12, 2023

Jiří Stanislav

 

Related posts

GIGA tools and tempering


Read more

Round or square hot zone?


Read more

So here it is ….


Read more

Jiří Stanislav, Ing., CSc.

Consultant for heat treatment of metals

Forensic expert in metallurgy and heat treatment of metals

IČ: 02232413

Elišky Krásnohorské 965
Liberec 14, 46001 Česká Republika

[email protected]

+420 603 235 924

Information

  • General terms and conditions of sale of courses

Cookie settings

Contact

[email protected]

+420 603 235 924

© 2021 tvorbu webu realizoval SEMTIX.cz
    0

    €0,00

    English
    • Czech
    • English

      Cookies on this website

      We use necessary cookies to make the website work (cart, language). With your consent we also use analytics cookies (Google Analytics, Microsoft Clarity) to improve the website and marketing cookies (Google Ads) to measure and target advertising. You can change your choice at any time via “Cookie settings” in the footer. Cookie policy (Czech)